Wandy3D brick set - how to build

What is in this folder
  instructions.pdf  building instructions: a cover, the parts list, then one layer per step
  parts.csv         every part you need: part number, colour, quantity
  bricklink.xml     the same list as a BrickLink wanted list
  model.ldr         the finished model in LDraw format (BrickLink Studio, LeoCAD, LDView)

All parts are standard 1-high bricks, 1 x 1 up to 2 x 8, with LDraw / BrickLink part numbers.

Getting the parts
  BrickLink: Wanted Lists > Upload (bricklink.com/v2/wanted/upload.page), choose
  "Upload BrickLink XML format", paste the contents of bricklink.xml, then verify and add.
  Bricks you already have work too. The grey bricks inside the model are never seen:
  any colour will do there (the cover says how many).

Building
  1. Start with layer 1 on a flat table or a baseplate. The bottom edge of every page is the
     front of the model.
  2. Each step is one layer seen from above: coloured bricks are the new layer, grey outlines
     are the layer underneath. The dots are the studs.
  3. Press every brick down firmly before you start the next layer.
  4. A brick outlined in red has nothing below it yet: hold it with a drop of glue, or prop it
     up until the layer above locks it in.
