Grok 4.7Yazar: Wësche

3D-printable J-hook for a load test, written as OpenSCAD

A comparison of J-hook designs from Grok 4.7, Claude Opus 5.5 and GPT-6 Astra, each an OpenSCAD file exported to STL for a PLA strength test.

Claude Code + Three.js (yalnızca kod)Wandy 2
Gerçek modeller · 360°İkisi de aynı fotoğraftan: solda — nesneyi Three.js koduyla modelleyen, düzenlenmemiş tek bir Claude Code (Opus 5.5) çalıştırması; sağda — Wandy 2.

Detaylı 3D modeller oluştur

Sadece kodla basit şekiller elde edersin. Wandy 2, tek bir fotoğrafı aynı sahnede kullanabileceğin dokulu bir 3D modele dönüştürür.

Grok 4.7 promptu

Design one 3D-printable J-hook for a strength test.
The hook hangs from an 8 mm steel bar. An 8 mm pin sits in the bill and we hang weight from that pin. I want the highest breaking load I can get without the bar or the pin slipping out.
Rules:
- One printed part. No screws, inserts, glue, or extra pieces.
- Must clip onto the bar and the pin by hand. No closed rings.
- Pin seats 40 mm apart, center to center.
- PLA. Max 35 g as printed.
- Must fit 80 x 60 x 25 mm.
- The pin should have to lift at least 10 mm to come out. If it can roll out the side, that design is invalid.
Give me:
1. A short explanation of the shape.
2. A complete OpenSCAD file I can compile and export to STL for Bambu Studio.
No STL text. No G-code. OpenSCAD only. If the first idea would slip off, replace it in the same answer.

Bu prompt nasıl kullanılır

  1. Paste the prompt into Grok 4.7, or another model to compare, and ask for the OpenSCAD file only.

  2. Change the bar and pin diameter, spacing, weight limit, material and build volume to match your hardware.

  3. Compile in OpenSCAD, export STL, slice and print, then compare breaking loads and ask for revisions.

Wandy3D'den

Sahnende gerçek bir 3D model mi lazım?

Ajanın sahneyi primitiflerle kuruyor. Wandy3D API'si bir fotoğrafı ya da promptu birkaç dakikada dokulu bir GLB'ye dönüştürür. Ödeme ön ödemeli bakiyeden yapılır, abonelik yok.

  • Wandy 2Model başına $0,18
  • Wandy 1Model başına $0,09

Bakiyenin süresi dolmaz · başarısız işlerin ücreti iade edilir · API ile yapılan modeller senindir, her formatta indirebilirsin.

curl -s -X POST https://api.wandy3d.com/generate/cloud/ultra \  -H "Authorization: Bearer $WANDY3D_API_KEY" -F "file=@photo.jpg"# → {"task_id": "…"} — poll until "status" is "done":curl -s https://api.wandy3d.com/task/$TASK_ID/status \  -H "Authorization: Bearer $WANDY3D_API_KEY"# → {"model_id": "…"} — then GET /model/$MODEL_ID/export?format=glb

Orijinal gönderiYazarı sen misin? Bu sayfayı düzenlememizi ya da kaldırmamızı iste