Routed 50 x 20 mm two-layer KiCad PCB with 3D renders

GPT-6 Astra took a schematic PDF through KiCad to a revised circuit and a routed two-layer board with zero DRC violations, plus 3D renders.

Routed 50 x 20 mm two-layer KiCad PCB with 3D renders
Claude Code + Three.js (yalnızca kod)Wandy 2
Gerçek modeller · 360°İkisi de aynı fotoğraftan: solda — nesneyi Three.js koduyla modelleyen, düzenlenmemiş tek bir Claude Code (Opus 5.5) çalıştırması; sağda — Wandy 2.

Detaylı 3D modeller oluştur

Sadece kodla basit şekiller elde edersin. Wandy 2, tek bir fotoğrafı aynı sahnede kullanabileceğin dokulu bir 3D modele dönüştürür.

Wandy3D'den yapım özeti

Yazar promptu paylaşmadı, bu yüzden bu çalışmayı nasıl yeniden yapabileceğini biz yazdık.

Build a small sensor-board design project in KiCad starting from a supplied schematic PDF. Redraw the schematic so it follows the PDF's layout and style, change only the sensor-interface section the user specifies, and keep every other part and connection unchanged. Review component datasheets and run the electrical rules check. Then lay out and route a 50 x 20 mm two-layer PCB with four corner mounting holes, a four-pin connector on one short edge, a microcontroller, a few small ICs, a boot button and labelled test pads. Use a dark green solder mask with silk-screen labels. Finish by running the design rule check until it reports zero violations, and export a 3D board render plus front and mirrored back layout views. Deliver the KiCad project, the schematic PDF and the renders, with a short note listing unresolved checks and the fact that hardware testing has not yet been done.

Bu prompt nasıl kullanılır

  1. Give the build brief to GPT-6 Astra in an agent that can drive KiCad, along with your own schematic PDF.

  2. Change the sensor section, board size, connector and mounting holes to match your hardware, and keep the rest fixed.

  3. You get a schematic, a routed board and 3D renders; re-run ERC and DRC, then ask for datasheet checks before ordering.

Wandy3D'den

Sahnende gerçek bir 3D model mi lazım?

Ajanın sahneyi primitiflerle kuruyor. Wandy3D API'si bir fotoğrafı ya da promptu birkaç dakikada dokulu bir GLB'ye dönüştürür. Ödeme ön ödemeli bakiyeden yapılır, abonelik yok.

  • Wandy 2Model başına $0,18
  • Wandy 1Model başına $0,09

Bakiyenin süresi dolmaz · başarısız işlerin ücreti iade edilir · API ile yapılan modeller senindir, her formatta indirebilirsin.

curl -s -X POST https://api.wandy3d.com/generate/cloud/ultra \  -H "Authorization: Bearer $WANDY3D_API_KEY" -F "file=@photo.jpg"# → {"task_id": "…"} — poll until "status" is "done":curl -s https://api.wandy3d.com/task/$TASK_ID/status \  -H "Authorization: Bearer $WANDY3D_API_KEY"# → {"model_id": "…"} — then GET /model/$MODEL_ID/export?format=glb

Orijinal gönderiYazarı sen misin? Bu sayfayı düzenlememizi ya da kaldırmamızı iste