GPT-6 AstraAutor: Titlist400

Routed 50 x 20 mm two-layer KiCad PCB with 3D renders

GPT-6 Astra took a schematic PDF through KiCad to a revised circuit and a routed two-layer board with zero DRC violations, plus 3D renders.

Routed 50 x 20 mm two-layer KiCad PCB with 3D renders
Claude Code + Three.js (nur Code)Wandy 2
Echte Modelle · 360°Beide aus demselben Foto: links — ein unbearbeiteter Lauf von Claude Code (Opus 5.5), der es in Three.js-Code modelliert; rechts — Wandy 2.

Detaillierte 3D-Modelle erstellen

Mit Code allein bekommst du einfache Formen. Wandy 2 macht aus einem Foto ein texturiertes 3D-Modell, das du in derselben Szene nutzen kannst.

Build-Briefing von Wandy3D

Der Autor hat keinen Prompt geteilt, also haben wir aufgeschrieben, wie du diesen Build nachbauen kannst.

Build a small sensor-board design project in KiCad starting from a supplied schematic PDF. Redraw the schematic so it follows the PDF's layout and style, change only the sensor-interface section the user specifies, and keep every other part and connection unchanged. Review component datasheets and run the electrical rules check. Then lay out and route a 50 x 20 mm two-layer PCB with four corner mounting holes, a four-pin connector on one short edge, a microcontroller, a few small ICs, a boot button and labelled test pads. Use a dark green solder mask with silk-screen labels. Finish by running the design rule check until it reports zero violations, and export a 3D board render plus front and mirrored back layout views. Deliver the KiCad project, the schematic PDF and the renders, with a short note listing unresolved checks and the fact that hardware testing has not yet been done.

So nutzt du diesen Prompt

  1. Give the build brief to GPT-6 Astra in an agent that can drive KiCad, along with your own schematic PDF.

  2. Change the sensor section, board size, connector and mounting holes to match your hardware, and keep the rest fixed.

  3. You get a schematic, a routed board and 3D renders; re-run ERC and DRC, then ask for datasheet checks before ordering.

Von Wandy3D

Brauchst du ein echtes 3D-Modell in deiner Szene?

Dein Agent baut mit Primitiven. Die Wandy3D API macht aus einem Foto oder Prompt in wenigen Minuten ein texturiertes GLB – bezahlt aus einem Prepaid-Guthaben, ohne Abo.

  • Wandy 20,18 $ pro Modell
  • Wandy 10,09 $ pro Modell

Das Guthaben verfällt nie · fehlgeschlagene Jobs werden erstattet · über die API erstellte Modelle gehören dir und lassen sich in jedem Format herunterladen.

curl -s -X POST https://api.wandy3d.com/generate/cloud/ultra \  -H "Authorization: Bearer $WANDY3D_API_KEY" -F "file=@photo.jpg"# → {"task_id": "…"} — poll until "status" is "done":curl -s https://api.wandy3d.com/task/$TASK_ID/status \  -H "Authorization: Bearer $WANDY3D_API_KEY"# → {"model_id": "…"} — then GET /model/$MODEL_ID/export?format=glb

OriginalbeitragBist du der Autor? Bitte uns, diese Seite zu ändern oder zu entfernen